NOTE: This filter set included 4 pins UV Lamp. If you are looking for 2 pins UV lamp click herePlease make sure before you purchase since we are selling botth 2 and 4 pins UV lamp. 1 set of replacement filters with following : 1 x Sediment Filter 5 micron Dirt/Rust remover Size 9 7/8 inch x 2.5 inch – Fits most standard 10 inch size housings and most reverse osmosis systems.Used to remove larger particles & suspended matter such as dirt, silt, rust, sand, algae, sediment, scale particles, and cloudiness from water. Meets FDA requirements for food and beverage contact. No leachable or extractable material to contaminate outflowing water. Long life and increased dirt holding capacity. No surface binders to reduce flow and increase change-out frequency. 1 x GAC 10 Inch Coconut shell Carbon Filter Size 9 7/8 inch x 2.5 inch – Fits most standard 10 inch size housings and most reverse osmosis systems. Remove Chlorine, Turbidity, Bad Taste & Odor, Sediment, Dirt, and THMS from water. Thick Wall Coconut Base Carbon Filter Media – 100% coconut shell carbon Designed For maximum contact between the water and carbon. 5 Micron filter membrane included to prevent carbon fines to pass from the filter to your drinking water. Operation Temperature: 40°F to 125°F 1 x CTO Carbon Block Filter Size 9 7/8 inch x 2.5 inch Fits most standard 10 inch size housings and most reverse osmosis systems. Remove small particles and carbon fines may pass from second stage & to ensure 100% of chlorine removal from water. 1 x 3-in-1 pH+ Alkaline/Far Infrared/Remineralization Filter Filter Service Life: 6 to 18 months maximum, Filter life varies and will be determine based on of the feed water quality and amount water the machine produce. Filter in out port size: 1/4″ NPTF. Filter Size: 2″W x 10″L Required Hardware:Two 1/4″ FTP Fittings ( 1/4″ tube connecters ) are required to connect this filter to your RO unit. part number: 105407, Two 2″x2.5″ double clamp are required to mount the filter to your RO system. part number: 105104 1 X 6 W UV bulb for UV Sterilizer Model NOTE: This lamp has a four post connectors on a cable from one end. Please check the lamp in your UV sterilizer before orderingIf your lamp has two posts on either end check out6 W UV bulbLight Power:6 WLight tube No. G6 T5 for UV Sterilizer110 VLight lifetime: 9000 hoursMade in Poland 1 x Standard Inline Carbon Cartridges Dimensions: 2 inch x 10 inch – Fits standard Reverse Osmosis Systems – 10 Micron Nominal Removes Chlorine , Bad Taste & Odor ,Turbidity ,Sediment ,THMs and Dirt. Helps to polish the taste of reverse osmosis water (Last Stage), Ice maker Refrigerators Drinking Coolers Max Flow: 0.5 GPM Max Pressure: 125 PSI Max Temperature: 100°F Inlet/Outlet: 1/4 inch NPTF thread (fitting is required) 1 X Reverse Osmosis Membrane NSF Certified. 50 GPD R.O. Membrane at 60 PSI We Suggest to change your membrane every 2 year To remove particles down to 1/10,000 of a micron ( which is 98% of impurities including Organic, inorganic And chemicals). –> 1 X Inline Remineralization Cartridge Dimensions: 2″ x 10″ – Fits all Reverse Osmosis Systems Filter Service Life: 1500 Gallons ( 5676 Liter) Max Flow: 0.75 GPM Max Pressure: 125 PSI (8.6 Bar) Max Temperature: 100°F Inlet/Outlet: 1/4″ NPT –> Total 6 filters, each individually wrapped. –> –>